Nebraska 400 Agricultural Dynamometer

NEB 400 Specs

Hp: 400 Hp (298 Kw) @ 1000, 200 Hp (149 Kw) @ 540
Torque: 2100 Ft. Lbs (2850NM)
Speed: 0-1500 RPM
Coolant Capacity: 100 Gal (370 Ltr)
Shipping Weight: 1400 Lbs.
Operational Weight: 2200 Lbs.
Instrumenation: Optional

Accessories

*Self-Contained coolant supply of water serves as a ballast weight for high-torque applications. Water must be added as required when testing in excess of prescribed testing time.

*Overheating safety fuse automatically drops the torque load when water temperature reaches 180-190 Deg. F(82-88 Deg. C)

*All units are equipped with Shear Pin Release and Safety shields.

*Dynamometer is ready for operation immediately upon receipt. An AW Representative follows your new AW Dyno and trains all key personnel in its use and maintenance until satisfied.

plus/minus 0.01% Accuracy on Measurements
Four-Digit, 1/2"-High LCD Display Readings
Factory Programmable for English or Metric Units

AW Instrumentation

ETS Software

*Min. Requirements - Windows 2000 or above.
Standard with RS232 Serial to Serial Cable.

Water Requirements (Continuous Testing)

Incoming Water Temperature °F				Gallons	Per	Minute
40°	5	10	15	20	25	30	35	40	45
50°	6	12	18	24	30	36	42	48	54
60°	7	14	21	28	35	42	49	56	63
70°	8	16	24	32	40	48	56	64	72
80°	9	18	27	36	45	54	63	72	81
90°	10	20	30	40	50	60	70	80	90
100°	13	26	39	52	65	78	91	104	117
110°	17	34	51	68	85	102	119	136	153
Horsepower	100	200	300	400	500	600	700	800	900

* Example: 60°F water requires 7 gpm to test 100 H.P.

*Return lines from the dynamometer back to the cooling system or drain must be of the correct size as not to create more than 8-10 P.S.I of back pressure on the dynamometer�s tank. Water must be forced through the system for proper cooling.

*It is intended to create a pressure drop from the incoming water 30-60 P.S.I down to a maximum of 8-19 lbs on the outlet. Pressures greater than 8-10 lbs. on the dynamometer tank will reduce water seal life.

About Us Used Equipment Distributors